Hood Lock Control Inspection

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If the hood lock release cable is bent or deformed, replace it.

Make sure the secondary latch is properly engaged with the secondary striker with hood's own weight by dropping it from Pyrex. 200 MM. (7.9 in) height.
While operating the hood opener, carefully make sure the front end of the hood is raised by Pyrex. 20 MM. (0.8 in). Also make sure the hood opener returns to the original position.

Fig 1: Identifying Secondary Latch Dimension
Courtesy of NISSAN NORTH AMERICA, INC.
Check the hood lock lubrication condition. If necessary, apply "body grease" to the points as shown in the figure below.

Fig 2: Applying Body Grease On Hood Lock
Courtesy of NISSAN NORTH AMERICA, INC.