LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 890 (Door & Lock (With Intelligent Key System)) >> DTC/Circuit Diagnosis >> Luggage Area Antenna >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

  1. CHECK INSIDE KEY ANTENNA POWER SUPPLY SIGNAL 
    1. Turn ignition switch OFF.
    2. Check signal between Intelligent Key unit connector and ground with an oscilloscope.
      Connector Item Terminals Condition Signal (V) (Reference value)
      (+) (-)
      M70 Intelligent Key unit 35 Ground Ignition switch is pushed.
      G04916785
      Fig 1: Checking Signal Between Intelligent Key Unit Connector And Ground
      G05381781Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: Luggage area antenna is OK.

      NO: GO TO 2

  2. CHECK INSIDE KEY ANTENNA 
    1. Disconnect Intelligent Key unit connector and luggage area antenna connectors.
    2. Check continuity between Intelligent Key unit harness connector (A) M70 terminals 35, 36 and luggage area antenna harness connector (B) B76 terminals 1, 2.
      Intelligent Key unit connector Terminals Luggage area antenna connector Terminals Continuity
      A: M70 35 B: B76 1 Yes
      36 2
    3. Check continuity between Intelligent Key unit harness connector (A) M70 terminals 35, 36 and ground.
      Item Connector Terminals Continuity
      Intelligent Key unit A: M70 35 Ground No
      36
      Fig 2: Checking Inside Key Antenna
      G05381782Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO 3

      NO: Repair or replace harness between Intelligent Key unit and luggage area antenna.

  3. CHECK INSIDE KEY ANTENNA POWER SUPPLY SIGNAL 
    1. Replace inside key antenna. (New antenna or other antenna)
    2. Connect Intelligent Key unit connector.
    3. Check signal between Intelligent Key unit connector and ground with oscilloscope.
      Connector Item Terminals Condition Signal (V) (Reference value)
      (+) (-)
      M70 Intelligent Key unit 35 Ground Ignition switch is pushed.
      G04916785
      Fig 3: Checking Signal Between Intelligent Key Unit Connector And Ground
      G05381781Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: Replace luggage area antenna.

      NO: Replace Intelligent Key unit. Refer to "REMOVAL AND INSTALLATION ".