LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 890 (Door & Lock (With Intelligent Key System)) >> DTC/Circuit Diagnosis >> Center Console Area Antenna (Rear) >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

  1. CHECK INSIDE KEY ANTENNA POWER SUPPLY SIGNAL 
    1. Turn ignition switch OFF.
    2. Check signal between Intelligent Key unit connector and ground with an oscilloscope.
      Connector Item Terminals Condition Signal (V) (Reference value)
      (+) (-)
      M70 Intelligent Key unit 15 Ground Ignition switch is pushed.
      G04916785
      Fig 1: Checking Signal Between Intelligent Key Unit Connector And Ground
      G05381776Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: Center console area antenna (rear) is OK.

      NO: GO TO 2

  2. CHECK INSIDE KEY ANTENNA 
    1. Disconnect Intelligent Key unit connector and center console area antenna (rear) connectors.
    2. Check continuity between Intelligent Key unit harness connector (A) M70 terminals 15, 16 and center console area antenna (rear) harness connector (B) M209 terminals 1, 2.
      Intelligent Key unit connector Terminals Center console area antenna (rear) connector Terminals Continuity
      A: M70 15 B: M209 1 Yes
      16 2
      Fig 2: Checking Inside Key Antenna
      G05381777Courtesy of NISSAN NORTH AMERICA, INC.
    3. Check continuity between Intelligent Key unit harness connector (A) M70 terminals 15, 16 and ground.
      Item Connector Terminals Continuity
      Intelligent Key unit A: M70 15 Ground No
      16

      Is the inspection result normal? 

      YES: GO TO 3

      NO: Repair or replace harness between Intelligent Key unit and center console area antenna (rear).

  3. CHECK INSIDE KEY ANTENNA POWER SUPPLY SIGNAL 
    1. Replace inside key antenna. (New antenna or other antenna)
    2. Connect Intelligent Key unit connector.
    3. Check signal between Intelligent Key unit connector and ground with oscilloscope.
      Connector Item Terminals Condition Signal (V) (Reference value)
      (+) (-)
      M70 Intelligent Key unit 15 Ground Ignition switch is pushed.
      G04916785
      Fig 3: Checking Signal Between Intelligent Key Unit Connector And Ground
      G05381776Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: Replace center console area antenna (rear).

      NO: Replace Intelligent Key unit. Refer to "REMOVAL AND INSTALLATION ".