Mid Sun Gear, Rear Sun Gear, High and Low Reverse Clutch Hub: Assembly

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Install new seal rings to mid sun gear.
CAUTION:
- Do not reuse seal rings.
- Apply petroleum jelly to seal rings.
Fig 1: Identifying Mid Sun Gear Seal Rings
Courtesy of NISSAN NORTH AMERICA, INC.
Install 1st one-way clutch to rear sun gear.
CAUTION: Apply petroleum jelly to 1st one-way clutch.

Fig 2: Installing 1st One-Way Clutch To Rear Sun Gear
Courtesy of NISSAN NORTH AMERICA, INC.
Install snap ring to rear sun gear using suitable tool.

Fig 3: Installing Snap Ring To Rear Sun Gear Using Suitable Tool
Courtesy of NISSAN NORTH AMERICA, INC.
Install rear sun gear assembly to mid sun gear assembly.

Fig 4: Installing Rear Sun Gear Assembly To Mid Sun Gear Assembly
Courtesy of NISSAN NORTH AMERICA, INC.
Install needle bearing to high and low reverse clutch hub.
CAUTION:
- Take care with the direction of needle bearing. Refer to "LOCATION OF ADJUSTING SHIMS, NEEDLE BEARINGS, THRUST WASHERS AND SNAP RINGS ".
- Apply petroleum jelly to needle bearing.
Fig 5: Installing Needle Bearing To High And Low Reverse Clutch Hub
Courtesy of NISSAN NORTH AMERICA, INC.
Install high and low reverse clutch hub to mid sun gear assembly.

Fig 6: Installing High And Low Reverse Clutch Hub To Mid Sun Gear Assembly
Courtesy of NISSAN NORTH AMERICA, INC.
Install snap ring to mid sun gear assembly using suitable tool.
CAUTION: Do not expand snap ring excessively.

Fig 7: Installing Snap Ring To Mid Sun Gear Assembly Using Suitable Tool
Courtesy of NISSAN NORTH AMERICA, INC.
Check operation of 1st one-way clutch.
1. Hold mid sun gear and turn rear sun gear.
2. Check 1st one-way clutch for correct locking and unlocking directions.
  CAUTION: If not as shown, check installation direction of 1st one-way clutch.
  
  Fig 8: Checking 1st One-Way Clutch For Correct Locking And Unlocking Directions
  Courtesy of NISSAN NORTH AMERICA, INC.
Install needle bearing and bearing races to high and low reverse clutch hub.
CAUTION:
- Apply petroleum jelly to needle bearing and bearing races.
- Take care with order of bearing races.
Fig 9: Identifying Needle Bearing And Bearing Races
Courtesy of NISSAN NORTH AMERICA, INC.