LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Automatic Transmission) >> DTC/Circuit Diagnosis >> DTC P1710: Transmission Fluid Temperature Sensor >> DTC Confirmation Procedure >> With Consult

With Consult

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Confirmation procedure 1

  1. Turn ignition switch "ON". (Do not start engine.)
  2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT.
  3. Start engine and maintain the following conditions for at least 14 minutes (Total). (It is not necessary to maintain continuously.)

    VHCL/S SE-A/T: 10 km/h (6 MPH) or more 

    ACCELE POSI: More than 1.0/8 

    SLCT LVR POSI: "D" position 

  4. If DTC is detected, go to "DIAGNOSIS PROCEDURE ".
  5. If DTC is not detected, go to "Confirmation procedure 2".

Confirmation procedure 2

  1. Turn ignition switch "ON". (Do not start engine.)
  2. Select "ATF TEMP 1" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT.
  3. Select "COOLANT TEMP/S" in "DATA MONITOR" mode for "ENGINE" with CONSULT.
  4. Check temperature difference between A/T fluid and engine coolant.
  5. When the temperature is calculated by subtracting the engine coolant temperature from A/T fluid temperature more than 47°C (116.6°F) or is it less than -19°C (-2.2°F), go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About LEMON Manuals