LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 888 (Automatic Transmission) >> DTC/Circuit Diagnosis >> DTC P0720: Output Speed Sensor >> DTC Confirmation Procedure >> With Consult

With Consult

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch "ON". (Do not start engine.)
  2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT.
  3. Drive vehicle and check for an increase of "VHCL/S SE-A/T" value in response to "VHCL/S SE.MTR" value.

    If the check result is NG, go to "DIAGNOSIS PROCEDURE ".

    If the check result is OK, go to following step.

  4. Select "DATA MONITOR" mode for "ENGINE" with CONSULT.
  5. Start engine and maintain the following conditions for at least 5 consecutive seconds.

    VHCL/S SE-A/T: 30 km/h (19 MPH) or more 

    ACCELE POSI: More than 1.0/8 

    SLCT LVR POSI: "D" position 

    Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. 

    If the check result is NG, go to "DIAGNOSIS PROCEDURE ".

    If the check result is OK, go to following step.

  6. Maintain the following conditions for at least 5 consecutive seconds.

    ENGINE SPEED: 3, 500 RPM or more 

    ACCELE POSI: More than 1.0/8 

    SLCT LVR POSI: "D" position 

    Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. 

    If the check result is NG, go to "DIAGNOSIS PROCEDURE ".

scientia non olet · About LEMON Manuals