Diagnosis Procedure

With CONSULT 

1. Turn ignition switch "ON". (Do not start engine.)
2. Select "SELECTION FROM MENU" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT and check monitor "STARTER RELAY" ON/OFF.

   Item name	Condition	Display value
   STARTER RELAY	Selector lever in "N", "P" positions.	ON
   	Selector lever in other positions.	OFF

Without CONSULT 

1. Turn ignition switch "ON". (Do not start engine.)
2. Check voltage between the IPDM E/R connector and ground.

   Item	Connector	Terminal		Shift position	Voltage (Approx.)
   Starter relay	E122	48	Ground	"N" and "P"	Battery voltage
   				"R" and "D"	0V

   Fig 1: Checking Voltage Between IPDM E/R Connector And Ground

   Courtesy of NISSAN NORTH AMERICA, INC.

   OK or NG 

   OK: GO TO  5.

   NG: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect A/T assembly harness connector and IPDM E/R connector.
3. Check continuity between A/T assembly harness connector and IPDM E/R connector.

   Item	Connector	Terminal	Continuity
   A/T assembly harness connector	F9	9	Yes
   IPDM E/R connector	E122	48

   Fig 2: Checking Continuity Between A/T Assembly Harness Connector And IPDM E/R Connector

   Courtesy of NISSAN NORTH AMERICA, INC.
4. If OK, check harness for short to ground and short to power.
5. Reinstall any part removed.

   OK or NG 

   OK: GO TO 3.

   NG: Repair open circuit or short to ground or short to power in harness or connectors.

1. Remove control valve with TCM. Refer to "CONTROL VALVE WITH TCM "
2. Disconnect A/T assembly harness connector and TCM connector.
3. Check continuity between A/T assembly harness connector terminal and TCM connector terminal.

   Item	Connector	Terminal	Continuity
   A/T assembly harness connector	F9	9	Yes
   TCM connector	F502	8

   Fig 3: Checking Continuity Between A/T Assembly Harness Connector Terminal And TCM Connector Terminal

   Courtesy of NISSAN NORTH AMERICA, INC.
4. If OK, check harness for short to ground and short to power.
5. Reinstall any part removed.

   OK or NG 

   OK: GO TO 4.

   NG: Replace open circuit or short to ground and short to power in harness or connectors.

Check the following items:

• Starter relay, Refer to "SYSTEM DESCRIPTION ".
• IPDM E/R, Refer to "PHYSICAL VALUES ".

  OK or NG 

  OK: Replace the control valve with TCM. Refer to "CONTROL VALVE WITH TCM ".

  NG: Repair or replace damaged parts.

Perform "DTC Confirmation Procedure".

• Refer to "DTC CONFIRMATION PROCEDURE ".

  OK or NG 

  OK: INSPECTION END 

  NG: GO TO  2.