Diagnosis Procedure

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CAN COMMUNICATION LINE
Perform the self-diagnosis. Refer to "CONSULT FUNCTION (TRANSMISSION) ".

Is a malfunction in the CAN communication indicated in the results?

YES: Check CAN communication line. Refer to "DIAGNOSIS PROCEDURE ".

NO: GO TO 2.
CHECK STOP LAMP SWITCH CIRCUIT
With CONSULT
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "ECU INPUT SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT.
3. Read out ON/OFF switching action of the "BRAKESW".
  OK or NG
  
  OK: INSPECTION END
  
  NG: GO TO 3.

CHECK STOP LAMP SWITCH

Check continuity between stop lamp switch terminals 1 and 2.

Condition	Continuity
When brake pedal is depressed.	Yes
When brake pedal is released.	No

Fig 1: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2

Courtesy of NISSAN NORTH AMERICA, INC.

Check stop lamp switch after adjusting brake pedal - refer to "INSPECTION AND ADJUSTMENT ".

OK or NG

OK: Check stop lamp switch circuit.

NG: Repair or replace stop lamp switch.