Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Use new bolts when installing the wheel hub and bearing assembly.
Tighten drive shaft nut to specification. Refer to "REMOVAL AND INSTALLATION ".
When installing disc rotor on wheel hub and bearing assembly, position the disc rotor according to alignment mark.
(When not using the alignment mark, refer to "DISC ROTOR: INSPECTION ".)
Install wheel and tire. Refer to "ROTATION ".

Fig 1: Identifying Alignment Mark On Disc Rotor, Wheel Hub And Bearing
Courtesy of NISSAN NORTH AMERICA, INC.