LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 880 (Front Final Drive (M205)) >> Unit Removal And Installation >> Front Final Drive >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove under cover (if equipped).
  2. Remove the drive shafts from the front final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove the front cross member.
  4. Remove the front propeller shaft from the front final drive assembly. Refer to "UNIT REMOVAL AND INSTALLATION ".
  5. Disconnect the vent hose from the front final drive assembly.
  6. Support the front final drive assembly using a suitable jack.
  7. Remove the front final drive assembly bolts (<==), then remove the front final drive assembly.
    CAUTION: Support the front final drive assembly while removing using a suitable jack.
    Fig 1: Locating Front Final Drive Assembly Bolts
    G04901838Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals