LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 880 (Front Final Drive (M205)) >> Removal And Installation >> Side Oil Seal >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove the differential side shaft and differential side flange using suitable tool.
    Fig 1: Removing Differential Side Shaft And Flange Using Suitable Tool
    G04901832Courtesy of NISSAN NORTH AMERICA, INC.
  3. Place a small hole in the side oil seal case using suitable tool.
    Fig 2: Identifying Small Hole On Side Oil Seal
    G04901828Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove the side oil seal using suitable tool as shown below.
    Fig 3: Removing Side Oil Seal Using Suitable Tool
    G04901829Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals