LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 880 (Front Final Drive (M205)) >> Removal And Installation >> Carrier Cover >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply 3 mm (0.12 in) bead of sealant to the mating surface of the carrier cover as shown below.
    CAUTION: Remove any old sealant adhering to the mating surfaces. Also remove any moisture, oil, or foreign material adhering to the application and mating surfaces.
  2. Install the carrier cover to the gear carrier. Tighten the bolts to the specified torque. Refer to "DISASSEMBLY AND ASSEMBLY ".
  3. Install the front final drive assembly. Refer to "REMOVAL AND INSTALLATION ".
    CAUTION: Fill the front final drive assembly with recommended differential gear oil. Refer to "CHECKING DIFFERENTIAL GEAR OIL ".
    Fig 1: Applying Bead Of Sealant To Mating Surface Of Carrier Cover
    G04901895Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals