LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 879 (Engine Control System (Introduction)) >> Basic Inspection >> Inspection And Adjustment >> Idle Air Volume Learning >> Operation Procedure >> With CONSULT

With CONSULT

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
  2. Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
  3. Start engine and warm it up to normal operating temperature.
  4. Check that all items listed under the topic PREPARATION (previously mentioned) are in good order.
  5. Select "IDLE AIR VOL LEARN" in "WORK SUPPORT" mode.
  6. Touch "START" and wait 20 seconds.
  7. Make sure that "CMPLT" is displayed on CONSULT screen. If "CMPLT" is not displayed, Idle Air Volume Learning will not be carried out successfully. In this case, find the cause of the incident by referring to the DIAGNOSTIC PROCEDURE  below.
  8. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications.
    ITEM SPECIFICATION
    Idle speed 650 ± 50 RPM (in P or N position)
    Ignition timing 15 ± 5° BTDC (in P or N position)
scientia non olet · About LEMON Manuals