LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 877 (Engine Cooling System) >> Removal And Installation >> Water Pump >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain engine coolant from the radiator. Refer to "CHANGING ENGINE COOLANT ".
    CAUTION: Perform when the engine is cold.
  2. Remove the engine cooling fan (crankshaft driven type). Refer to "REMOVAL AND INSTALLATION (CRANKSHAFT DRIVEN TYPE) ".
  3. Remove the water pump pulley.
  4. Remove the water pump.
    • Engine coolant will leak from the cylinder block, so have a receptacle ready below.
      CAUTION: Handle water pump vane so that it does not contact any other parts.
scientia non olet · About LEMON Manuals