Crankshaft End Play

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Move the crankshaft fully forward and backward and measure the clearance between the thrust bearings and crankshaft arm using suitable tool.
Standard: 0.10 - 0.26 mm (0.0039 - 0.0102 in)

Limit: 0.30 mm (0.0118 in)

Fig 1: Measuring Crankshaft End Play Using Dial Gauge
Courtesy of NISSAN NORTH AMERICA, INC.
If measured value exceeds the repair limit, replace the thrust bearings, and measure again. If it still exceeds the repair limit, replace crankshaft also.