Connecting Rod Bearing (Big End)

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Install the connecting rod cap without the connecting rod bearing installed. After tightening the connecting rod bolt to the specified torque, measure the connecting rod large end inside diameter. Refer to "DISASSEMBLY AND ASSEMBLY ".
Standard: 57.000 - 57.013 mm (2.2441 - 2.2446 in)

Fig 1: Identifying Connecting Rod Bearing Big End Diameter
Courtesy of NISSAN NORTH AMERICA, INC.
If measurement exceeds the standard, replace connecting rod.