Inspection After Installation
WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
- Before starting engine, check oil/fluid levels including engine coolant and engine oil. If less than required quantity, fill to the specified level. Refer to
"FOR USA AND CANADA: FLUIDS AND LUBRICANTS
" (United States and Canada) or
"FOR MEXICO: FLUIDS AND LUBRICANTS
" (Mexico).
- Use procedure below to check for fuel leakage.
- Turn ignition switch ON (with engine stopped). With fuel pressure applied to fuel piping, check for fuel leakage at connection points.
- Start engine. With engine speed increased, check again for fuel leakage at connection points.
- Run engine to check for unusual noise and vibration.
NOTE:
If hydraulic pressure inside timing chain tensioner drops after removal and installation, slack in the guide may generate a pounding noise during and just after engine start. However, this is normal. Noise will stop after hydraulic pressure rises.
- Warm up engine thoroughly to make sure there is no leakage of fuel, exhaust gas, or any oils/fluids including engine oil and engine coolant.
- Bleed air from passages in lines and hoses, such as in cooling system.
- After cooling down engine, again check oil/fluid levels including engine oil and engine coolant. Refill to specified level, if necessary.
- Summary of the inspection items:
| Item |
Before starting engine |
Engine running |
After engine stopped |
| Engine coolant |
Level |
Leakage |
Level |
| Engine oil |
Level |
Leakage |
Level |
| Transmission/transaxle fluid |
A/T and CVT Models |
Leakage |
Level/Leakage |
Leakage |
| M/T Models |
Level/Leakage |
Leakage |
Level/Leakage |
| Other oils and fluids |
Level |
Leakage |
Level |
| Fuel |
Leakage |
Leakage |
Leakage |
| Exhaust gas |
- |
Leakage |
- |