LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Engine Mechanical) >> Removal And Installation >> Oil Seal >> Removal and Installation of Front Oil Seal >> Removal

Removal and Installation of Front Oil Seal: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the drive belt. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove radiator. Refer to "REMOVAL AND INSTALLATION ".
  3. Remove drive plate cover.
  4. Lock crankshaft using Tool (A).

    Tool number: - (J-47245) 

    Fig 1: Securing Crankshaf Using Tool
    G04899768Courtesy of NISSAN NORTH AMERICA, INC.
  5. Match mark crankshaft pulley bolt flange and crankshaft pulley for installation.
  6. Remove the crankshaft pulley bolt and crankshaft pulley from the crankshaft using suitable tool.
    Fig 2: Removing Crankshaft Pulley Bolt From Crankshaft Using Tool
    G04899699Courtesy of NISSAN NORTH AMERICA, INC.
  7. Remove the front oil seal using suitable tool.
    CAUTION: Do not damage front cover and oil pump drive spacer.
    Fig 3: Removing Front Oil Seal Using Tool
    G04899765Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals