LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Engine Mechanical) >> Removal And Installation >> Intake Valve Timing Control >> Intake Valve Timing Control Position Sensor (RH) >> Removal

Intake Valve Timing Control Position Sensor (RH): Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine room cover using power tool. Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect intake valve timing control position sensor harness connector (RH).
  3. Remove intake valve timing control position sensor (RH) (1) and O-ring (2) from Intake valve timing control solenoid valve cover (RH) (3).
    CAUTION: Do not reuse O-ring.
    Fig 1: Identifying RH Intake Valve Timing Control Position Sensor, Cover And O-Ring
    G06590212Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals