LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Engine Mechanical) >> Removal And Installation >> Intake Valve Timing Control >> Camshaft Position Sensor (PHASE) >> Removal

Camshaft Position Sensor (PHASE): Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine room cover using power tool. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove air duct and resonator assembly. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect camshaft position sensor harness connector.
  4. Remove camshaft position sensor (2) and O-ring (3) from Intake valve timing control solenoid valve cover (LH) (1).
    CAUTION: Do not reuse O-ring.
    Fig 1: Identifying Camshaft Position Sensor, Cover And O-Ring (PHASE)
    G06590213Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals