Cylinder Head Distortion

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Remove any oil, scale, gasket, sealant and carbon deposits from the cylinder head surface.
CAUTION: Do not allow any debris to enter the oil or coolant passages.
Measure the bottom surface of the cylinder head for distortion in six directions as shown below, using suitable tools.
Standard: 0.03 mm (0.0012 in)

Limit: 0.1 mm (0.004 in)

Fig 1: Measuring Cylinder Head Distortion Using Tools
Courtesy of NISSAN NORTH AMERICA, INC.
- If measurement exceeds the limit, replace the cylinder head.