LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Engine Mechanical) >> Periodic Maintenance >> Drive Belts >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air duct and resonator assembly. Refer to "REMOVAL AND INSTALLATION ".
  2. Install Tool on drive belt auto-tensioner pulley bolt, move in the direction of arrow (loosening direction of tensioner) as shown below.

    Tool number: - (J-46535) 

    Fig 1: Installing Tool On Drive Belt Auto-Tensioner Pulley Bolt
    G04899650Courtesy of NISSAN NORTH AMERICA, INC.
    WARNING: Avoid placing hand in a location where pinching may occur if the holding tool accidentally comes off.
  3. Remove the drive belt.
scientia non olet · About LEMON Manuals