LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Heater & Air Conditioning System) >> Removal And Installation >> High-Pressure Pipe >> Removal and Installation for High-Pressure Pipe >> Removal

Removal and Installation for High-Pressure Pipe: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Disconnect both the negative and positive battery terminals, then wait at least three minutes.
  1. Remove the cowl top extension. Refer to "REMOVAL AND INSTALLATION ".
  2. Disconnect the negative and positive battery terminals and wait at least three minutes. Refer to "REMOVAL AND INSTALLATION ".
  3. Reposition the IPDM E/R aside. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".
  4. Remove the front wheel and tire assembly (RH). Refer to "ROTATION ".
  5. Remove the front fender protector (RH). Refer to "REMOVAL AND INSTALLATION ".
  6. Position aside the front floor insulator.
  7. Discharge the refrigerant. Refer to "HFC-134A (R-134A) SERVICE PROCEDURE ".
  8. Remove the low-pressure pipe. Refer to "REMOVAL AND INSTALLATION FOR LOW-PRESSURE PIPE ".
  9. Remove the high-pressure pipe.
    CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
scientia non olet · About LEMON Manuals