Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

Discharge the refrigerant. Refer to "HFC-134A (R-134A) SERVICE PROCEDURE ".
Remove the radiator. Refer to "REMOVAL AND INSTALLATION ".
CAUTION:
- Be careful not to damage the core surface of the condenser and the radiator.
Disconnect the high-pressure flexible hose and the high-pressure pipe from the condenser.
CAUTION: Cap or wrap the joint of the pipe with suitable material such as vinyl tape to avoid the entry of air.
Disconnect the harness connector from the refrigerant pressure sensor.
- Remove the refrigerant pressure sensor from the condenser (if necessary).
Lift the condenser out of the grommets to remove.

Fig 1: Identifying Refrigerant Pressure Sensor And Horns
Courtesy of NISSAN NORTH AMERICA, INC.