LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 873 (SRS Airbag) >> Removal And Installation >> Side Air Bag (Satellite) Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least three minutes.
  • Do not use old nuts after removal; replace with new nuts.
  • Check side air bag (satellite) sensor to make sure it is free of deformities, dents, cracks or rust. If it shows any visible signs of damage, replace it with new one.
  • Do not disassemble side air bag (satellite) sensor.
  • Replace side air bag (satellite) sensor if it has been dropped or sustained an impact.
  1. Disconnect both the negative and positive battery terminals, then wait at least three minutes. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove seat belt retractor and belt assembly anchor bolt and retractor bolt upper, then set assembly aside. Refer to "REMOVAL AND INSTALLATION OF FRONT SEAT BELT ".
  3. Remove side air bag (satellite) sensor nuts.
  4. Disconnect the side air bag (satellite) sensor harness connector.
    Fig 1: Side Air Bag Sensor Harness Connector And Bolt With Torque Specifications
    G04902431Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals