LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 873 (SRS Airbag) >> Removal And Installation >> Crash Zone Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before servicing the SRS, turn the ignition switch off, disconnect both battery cables and wait at least three minutes.
  • Replace crash zone sensor if it has been dropped or sustained an impact.
  • Do not disassemble crash zone sensor.
  1. Disconnect both the negative and positive battery terminals, then wait at least three minutes. Refer to "REMOVAL AND INSTALLATION ".
  2. Remove front grille. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect the crash zone sensor harness connector.
  4. Remove crash zone sensor nuts.
    Fig 1: Crash Zone Sensor And Nut With Torque Specifications
    G04902430Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals