Body Rocker Panel Moulding LH: Replacement

WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.

REMOVE BODY ROCKER PANEL MOULDING LH
1. Remove the 8 retainers.
2. Using a screwdriver, remove the moulding.
  HINT:
  
  Tape the screwdriver tip before use.
3. Remove the 7 clips from the moulding.
Fig 1: Removing Body Rocker Panel Moulding LH
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BODY ROCKER PANEL MOULDING LH
1. Install the moulding with 7 new clips.
2. Install the 8 retainer to the moulding.
Fig 2: Installing Body Rocker Panel Moulding LH
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002