LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 510 (Wiper System & Washer System) >> Wiper Rubber LH >> Replacement

Wiper Rubber LH: Replacement

WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FR WIPER BLADE LH 
    1. Remove the front wiper blade LH from the front wiper arm LH.
    NOTE: Do not fold down the front wiper arm with the front wiper blade being removed from it.
  2. REMOVE WIPER RUBBER LH 
    1. Remove the front wiper rubber LH from the front wiper blade.
    2. Remove the 2 wiper rubber backing plates from the wiper rubber LH.
  3. INSTALL WIPER RUBBER LH 
    1. Install the 2 wiper rubber backing plates to the wiper rubber LH.
      NOTE: Be careful to observe and keep direction of curvature for correct replacement.
      Fig 1: Installing Wiper Rubber Backing Plates To Wiper Rubber LH
      G02900382Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the wiper rubber LH so that the head part (Larger side) of the wiper rubber faces the arm axle side.
      NOTE: Push the front wiper blade into the grooves of the wiper rubber to engage them completely.
    Fig 2: Installing Wiper Rubber LH
    G02900383Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals