LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Combination Meter - Diagnostics) >> Combination Meter >> Seat Belt Warning Lamp For Front Passenger's Seat Does Not Flash >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT COMBINATION METER ASSY 
    1. Ground terminal C9-11 on the combination meter side.
    2. Check that the warning light lights up.

      OK: Warning light lights up. 

      Fig 1: Locating Passenger Belt Switch Connector Terminal
      G02861056Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. OK: GO to step   3 
    2. NG: GO to Next step. 
  2. INSPECT PASSENGER SEAT BELT WARNING LAMP ASSY 
    1. Ground terminal C9-6 on the combination meter side.
    2. Check that the warning light lights up.

      OK: Warning light lights up. 

      Fig 2: Locating Passenger Belt Out Connector Terminal
      G02861057Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: CHECK AND REPLACE PASSENGER SEAT BELT WARNING LAMP ASSY 
    2. OK: CHECK AND REPLACE COMBINATION METER ASSY 
  3. INSPECT FRONT SEAT INNER BELT ASSY RH 
    1. Check continuity.
      1. Disconnect the front seat inner belt assy.
      2. Check the continuity in between terminals 1 and 2 of front seat inner belt assy RH.

        OK: 

        FRONT SEAT INNER BELT ASSY RH CONTINUITY SPECIFICATION

        Condition Continuity
        Seat belt is fastened Continuity
        Seat belt is unfastened No continuity
        Fig 3: Locating Front Seat Inner Belt Assy RH Connector Terminals
        G02861058Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG:CHECK AND REPLACE FRONT SEAT INNER BELT ASSY RH 
    2. OK: GO to Next step. 
  4. INSPECT SEPARATE SEAT TYPE FRONT SEAT CUSHION PAD 
    1. Disconnect the separate type front seat cushion pad.
    2. Check continuity separate type front seat cushion pad.
      FRONT SEAT CUSHION PAD CONTINUITY SPECIFICATION

      Sear condition Terminal Specified condition
      Released 1 - 2 No continuity
      Pressed 1 - 2 Continuity
      Fig 4: Inspecting Separate Seat Type Front Seat Cushion Pad
      G02861059Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: CHECK AND REPLACE SEPARATE SEAT TYPE FRONT SEAT CUSHION PAD 
    2. OK: REPAIR OR REPLACE HARNESS AND CONNECTOR 
scientia non olet · About LEMON Manuals