LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Combination Meter - Diagnostics) >> Combination Meter >> Seat Belt Warning Lamp For Driver's Seat Does Not Operate >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK COMBINATION METER ASSY 
    1. Ground terminal C9-12 on the combination meter side.
    2. Check that the warning light lights up.

      OK: Warning light lights up. 

      Fig 1: Locating Driver's Seat Belt Warning Switch Connector
      G02861053Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: CHECK AND REPLACE COMBINATION METER ASSY 
    2. OK: GO to Next step. 
  2. INSPECT FRONT SEAT INNER BELT ASSY LH 
    1. Disconnect the front seat inner belt assy.
    2. Check continuity front seat inner belt assy.
      FRONT SEAT INNER BELT TERMINAL CONTINUITY

      Belt condition Terminal Specified condition
      Belt unfastened 1 - 2 Continuity
      Belt fastened 1 - 2 No continuity
      Fig 2: Locating Front Seat Inner Belt Assy LH Connector Terminals
      G02861054Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: REPLACE FRONT SEAT INNER BELT ASSY LH 
    2. OK: REPAIR OR REPLACE HARNESS OR CONNECTOR 
scientia non olet · About LEMON Manuals