Inspection Procedure

1. Check speaker installation condition.
   1. Check that each speaker is securely installed.

      Standard: malfunction disappear. 

   HINT:

   The radio is equipped with noise prevention system that does not work against the regular use of the radio, thereby excessively large noise cannot occur in the radio. If large noise occurs, check whether or not the earth on the antenna installation part and the proper noise-prevention equipment are all installed, and whether or not the improper wiring is held.

   NOISE OCCURRING CONDITION
   
   

   Condition in which noise occurs	Noise type
   Depressing the acceleration pedal increases noise, and stopping the engine erases the noise immediately.	Alternator noise
   Noise occurs during the A/C or the heater operation.	Blower motor noise
   Rapid acceleration during the drive on the unpaved road or after the IG switch is turned ON makes noise.	Fuel pump noise
   Pressing and then releasing the horn switch, and keeping pressing the horn switch makes noise.	Horn noise
   Stopping the engine erases the small noise that has been heard.	Ignition noise
   Noise occurs in turn with the blink of the turn signal flash.	Flasher noise
   Noise occurs during the window washer operation.	Washer noise
   Noise occurs during the engine running, and it continues to occur after the, engine is stopped.	Water temperature sensor noise
   Noise occurs during the wiper operation.	Wiper noise
   Noise occurs when the brake pedal is depressed.	Stop light switch noise
   Others.	Static electricity on the vehicle

HINT:

• Identify the condition under which the noise occurs, and check the noise filter on the related part.
• Make sure first that there is no noise from outside. Failing to do so makes the noise occurrence source detection impossible and leads to misunderstanding.
• The noise should be removed in descending order of loudness.

1. NG: INSTALL IT PROPERLY 
2. OK: IDENTIFICATION OF NOISE SOURCE