LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 464 (Abs With EBD System - Diagnostics) >> Abs With EBD System (April, 2003) >> Brake Warning Light Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT PARKING BRAKE SWITCH CIRCUIT 
    1. Check for open and short circuit in parking brake switch circuit (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE PARKING BRAKE SWITCH CIRCUIT 
    2. OK: GO TO NEXT STEP. 
  2. INSPECT BRAKE FLUID LEVEL WARNING SWITCH CIRCUIT 
    1. Check the brake fluid level in reservoir.
    2. Check for open and shot circuit in brake fluid level warning switch circuit (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE BRAKE FLUID LEVEL WARNING SWITCH CIRCUIT 
    2. OK: GO TO NEXT STEP. 
  3. CHECK DTC ONCE MORE 
    1. Check for open and short circuit in harness and connector between vacuum warning switch and skid control ECU (See PRE-CHECK ).
    1. NG: REPAIR CIRCUIT INDICATED BY OUTPUT CODE 
    2. OK: GO TO NEXT STEP. 
  4. INSPECT COMBINATION METER ASSEMBLY (BRAKE WARNING LIGHT CIRCUIT) 
    1. Check for open and short circuit in combination meter (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE COMBINATION METER ASSEMBLY 
    2. OK: GO TO NEXT STEP. 
  5. CHECK HARNESS AND CONNECTOR (BRAKE ACTUATOR - COMBINATION METER) 
    1. Check for open and short circuit in harness and connector between brake actuator and combination meter (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).
    1. NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 
    2. OK: CHECK AND REPLACE BRAKE ACTUATOR ASSY 
scientia non olet · About LEMON Manuals