Typical Enabling Conditions
WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS
| Item | Specification | |
|---|---|---|
| Minimum | Maximum | |
| The monitor will run whenever the following DTCs are not present | See LIST OF DISABLE A MONITOR | |
| w/o ABS: | ||
| Engine coolant temperature | 70°C | - |
| Engine speed | 2,000 rpm | 5,000 rpm |
| Intake air amount per engine revolution | 0.42 g/rev | - |
| Fuel cut at high engine speed | Not executing | |
| w/ ABS: | ||
| Either of following condition is met | (a) or (b) | |
| (a) Following conditions are met | 1 and 2 | |
| 1. Engine coolant temperature | 20°C | - |
| 2. Time after park/neutral position switch ON to OFF | 10 seconds | - |
| (b) Following conditions are met | 1 and 2 | |
| 1. Engine coolant temperature | - | 20°C |
| 2. Time after park/neutral position switch ON to OFF | 30 seconds | - |
| Engine speed | 2650 rpm (vary with throttle opening angle) | - |
| Detection time on intake air temperature | 2 seconds (Intake air temperature is -10°C or more) 8 seconds (Intake air temperature less than -10°C) |
- |
| Time after IG SW ON | 3 seconds | - |