Monitor Result (Mode 06 Data)
WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
MONITOR RESULT (MODE 06 DATA)
| Test ID | Comp ID | Description of Test Data | Description of Test Limit | Unit | Conversion Factor |
|---|---|---|---|---|---|
| $02 | $81 | Tank pressure change value during vacuum introduction | Malfunction criteria for VSV for EVAP | mmHg | Multiply by 0.0916 |
| $82 | Fuel tank pressure change value at switching over the canister close valve or VSV for pressure switching valve. | Malfunction criteria for canister close valve and VSV for pressure switching valve | mmHg | Multiply by 0.0458 minus 2.930 | |
| $03 | Fuel tank pressure change 5 seconds after the end the vacuum introduction cycle Conditions:
|
Malfunction criteria for 0.040 leak | mmHg | Multiply by 0.0458 | |
| $04 | Malfunction criteria for 0.020 leak | mmHg | Multiply by 0.0458 |
Refer to CHECKING MONITOR STATUS for detailed information on Checking Monitor Status.