Typical Enabling Conditions
WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS
| Item | Specification | |
|---|---|---|
| Minimum | Maximum | |
| The monitor will run whenever the following DTCs are not present | See LIST OF DISABLE A MONITOR | |
| Battery voltage | 8V | - |
| VVT | Normal operation (i.e. not under scan-tool control) | |
| Engine speed fluctuation | Engine speed should not have changed rapidly | |
| Engine speed (Two full revolutions (2 rev.) after engine has started) | 450 rpm | 6,700 rpm (AT) 6,600 rpm (MT) |
| Engine coolant temperature | -10°C (14°F) | - |
| Intake air temperature | -10°C (14°F) | - |
| Intake air amount per revolution (varies with engine speed) | 0.14 g/rev | - |
| Throttle position learning | Completed | |
| Throttle position | Rapid throttle opening or closing operation has not occurred | |
| - | Changing value of throttle position greater than 0.5° per 0.008 seconds | |
| Transient spark retard (The spark timing delay control in a short time for preventing surge at the time of a sudden acceleration.) | Not commanded | |
| Rough road counter | - | 10 times/1,000 revolutions (not running on rough road) |