Typical Enabling Conditions
WARNING: This page is about a different car, the 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS
| Item | Specification | |
|---|---|---|
| Minimum | Maximum | |
| The monitor will run whenever the following DTCs are not present | See LIST OF DISABLE A MONITOR | |
| Case 1: | ||
| Vehicle speed | 2 mph (3 km/h) | - |
| Idle | OFF | |
| Fuel cut | OFF | |
| Time after fuel cut ON to OFF | 5 seconds | - |
| Intake air amount per revolution | 0.3 g/rev (AT) 0.22 g/rev (MT) |
- |
| Case 2 (Output voltage): | ||
| Time while the following conditions A and B are met | 290 seconds (Engine coolant temperature is less than 75°C (167°F)) 240 seconds (Engine coolant temperature is 75°C (167°F) or more) |
- |
| A. Fuel system status | Closed-loop | |
| B.Idle | OFF | |
| Deceleration count (The number of times accelerating and decelerating) | 30 times | - |
| Deceleration is counted up when vehicle decelerates | 3 mph (5 km/h) / 2 seconds | - |