Removal & Installation
WARNING: This page is about a different car, the 2004 Toyota Matrix and 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM.
- Remove appropriate front and rear door scuff plates. Remove front and rear door opening trim. On Corolla models, remove lap belt outer anchor cover. On all models, remove center pillar lower garnish. Remove upper and lower seat belt anchor bolt covers and anchor bolts. Disconnect pretensioner connector and retractor switch connectors. Remove seat pretensioner mounting bolts and pretensioner/retractor assembly.
- To install, reverse removal procedure. Tighten seat belt anchor bolts and pretensioner bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM.