LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 262 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC 31/B1100: Air Bag Sensor Assembly Malfunction >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2004 Toyota Matrix and 2004 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Access air bag sensor assembly and disconnect harness connector A13. See AIR BAG SENSOR ASSEMBLY  under REMOVAL & INSTALLATION. See Figure. Reconnect negative battery cable.
  2. Turn ignition switch to ON position. Measure voltage between ground and air bag sensor assembly connector A13, terminals No. 5 (circuit IG2, Black/Orange wire) and No. 27 (circuit ACC, White/Black wire) independently. See Figure. If voltage is less than 10-14 volts, go to next step. If voltage is not 10-14 volts, check battery and charging system operation.
  3. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect air bag sensor harness connector A13. Connect negative battery cable and wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES  under DIAGNOSTICS. If DTC 31/B1100 is displayed, replace air bag sensor assembly. If DTC 31/B1100 is not displayed, system is functioning properly at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT .
scientia non olet · About LEMON Manuals