How To Proceed With Troubleshooting

The hand-held tester can be used at step 3, 6, 9, 12.

1. Vehicle Brought to Workshop 
   1. Go to next step.
2. Customer Problem Analysis (See  CUSTOMER PROBLEM ANALYSIS CHECK  ) 
   1. Go to next step.
3. Check and Clear DTCs and Freeze Frame Data (See  PRE-CHECK  ) 
   1. Go to next step.
4. Problem Symptom Confirmation 
   1. Symptom does not occurs: Go to step 5 
   2. Symptom occurs: Go to step   6 . 
5. Symptom Simulation (See  ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ) 
   1. Go to next step.
6. PTC Check (See  PRE-CHECK  ) 
   1. There is no output: Go to step 7 
   2. There is output: Go to step   8 . 
7. Problem Symptoms Table (See  PROBLEM SYMPTOMS TABLE  ) 
   1. Check for fluid leakage and Go to step   10 . 
8. PTC Chart (See  DIAGNOSTIC TROUBLE CODE CHART  ) 
   1. Go to next step.
9. Circuit Inspection (See DTC C0200/31 RIGHT FRONT SPEED SENSOR, DTC C0205/32 LEFT FRONT SPEED SENSOR, DTC C1235/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR, DTC C1236/36 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR  to TS AND CG TERMINAL CIRCUIT )
   1. Go to next step.
10. Identification of Problem 
    1. Go to next step.
11. Repair 
    1. Go to next step.
12. Confirmation Test 
    1. Go to next step.
    2. End