LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> Tundra Base, Standard >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Stabilizer Bar (Sport Suspension Package) >> Removal

Rear Stabilizer Bar (Sport Suspension Package): Removal

  1. REMOVE REAR WHEELS 
    1. Torque: 110 N.m (1,150 kgf.cm, 83 ft.lbf) 
  2. SUPPORT REAR AXLE HOUSING WITH JACK 
  3. REMOVE STABILIZER BAR LINKS 
      NOTE:

      If the ball joint stud turns together with the nut, use a hexagon wrench to hold the stud.

      Fig 1: Removing Stabilizer Bar Link
      G02901500Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Remove the 2 nuts and stabilizer bar link.
      1. Torque: 69 N.m (704 kgf.cm, 51 ft.lbf) 
    2. Employ the same manner described above to the other side.
  4. REMOVE STABILIZER BAR FROM REAR AXLE HOUSING 
    1. Remove the 4 bolts and stabilizer bar with the bushings and brackets.
      Fig 2: Removing Stabilizer Bar, Bushings And Brackets
      G02901501Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Torque: 29 N.m (296 kgf.cm, 21 ft.lbf) 
    2. Remove the 2 brackets and 2 bushings from the stabilizer bar.
scientia non olet · About LEMON Manuals