LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> Tundra Base, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Adjustments >> Disc RUNOUT & Thickness

Disc RUNOUT & Thickness

For procedure, see Fig 1. For specifications, see DISC BRAKE SPECIFICATIONS  table.

NOTE: If disc runout is maximum value or greater, check the bearing play in the axial direction and check the axle hub runout. Maximum runout should not exceed .002 in. (.05 mm).
Fig 1: Front Disc Inspection Procedure
G00301573Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals