BRAKELIGHT Switch
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Toyota RAV4, 2002 Toyota Highlander, 2002 Toyota Camry, 2002 Lexus RX 300, and 2001 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For circuit reference, see CONNECTOR IDENTIFICATION and/or WIRING DIAGRAMS
.
On models without cruise control (2-pin connector), continuity should exist between terminals No. 1 and 2 with brake pedal depressed, and should not exist with brake pedal released. On models with cruise control (4-pin connector), continuity should exist between terminals No. 1 and 2 with brake pedal depressed, and should not exist with brake pedal released. Continuity should not exist between terminals No. 3 and 4 with brake pedal depressed, and should exist with brake pedal released. See Fig 1. Replace switch if continuity is not as specified.