LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2003 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 807 (Automatic Transmission (On-Vehicle Service)) >> Park/Neutral Position Switch ASSY >> Adjustment

Park/Neutral Position Switch ASSY: Adjustment

WARNING: This page is about a different car, the 2005 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSY 
    1. Apply the parking brake and turn the ignition switch ON.
    2. Depress the brake pedal and check that the engine starts only when the shift lever is set in N or P position and it does not start in other positions.
    3. Check that the back-up light is lit and the reverse warning buzzer sounds only when the shift lever is set in R position and these do not function in other positions.

      If a failure is found, check the park/neutral position switch for continuity.

  2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSY 
    1. Loosen the bolt of park/neutral position switch and set the shift lever to the N position.
    2. Align the groove and neutral basic line.
    3. Hold the switch in position and tighten the bolt.

      Torque: 13 N.m (130 kgf.cm, 9 ft.lbf) 

    4. After adjustment, perform the inspection described in step 1.
      Fig 1: Adjusting Park/Neutral Position Switch Assy
      G02573400Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals