Inspection Procedure

WARNING: This page is about a different car, the 2005 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When replacing the master cylinder solenoid, perform zero point CALIBRATION .

RECONFIRM DTC

HINT:

These codes are detected when a problem is determined in the master cylinder solenoid.

The solenoid circuit is in the master cylinder solenoid.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTC is output before replacing the master cylinder solenoid.

Clear the DTCs (see DTC CHECK/CLEAR ).

Check if the same DTCs are detected (see DTC CHECK/CLEAR ).

Result:

RESULT DESCRIPTION

DTC is output	A
DTC is not output	B

B: END
A: GO TO NEXT STEP
REPLACE MASTER CYLINDER SOLENOID (SEE OVERHAUL )