Park/Neutral Position Switch (CAMRY, Es 300, Highlander & RAV4): Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Toyota RAV4, 2002 Toyota Highlander, 2002 Toyota Camry, 2002 Lexus RX 300, and 2001 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- Install switch on control shaft. Loosely install PNP position switch adjusting bolts. Install seal and lock washer. Install lock nut and tighten to specification. See TORQUE SPECIFICATIONS . Bend tabs on lock washer over against lock nut.
- Ensure parking brake is applied. Temporarily install manual lever. Turn lever counterclockwise until it stops, then turn clockwise 2 notches. Remove manual lever. Rotate switch and align reference mark on switch with groove. See Fig 1. Hold switch in this position. Tighten 2 adjusting bolts to specification See TORQUE SPECIFICATIONS . Stake lock tab onto nut. Install manual lever, washer and nut. Tighten nut to specification. Install shift control cable and nut. Tighten nut to specification. Connect switch connector.