Master Cylinder: Removal
WARNING: This page is about a different car, the 2004 Toyota Corolla and 2003 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
Remove battery and disconnect level warning switch connector. See Fig 1. Draw brake fluid from reservoir with a syringe. On models with M/T, disconnect reservoir hose. Disconnect and plug brake lines. On models with ABS, remove 2 mounting nuts. Pull out check valve bracket and master cylinder. Remove gasket from cylinder. On models without ABS, remove 2 mounting nuts. Pull out check valve bracket, 3-way and master cylinder. Pull out reservoir stopper. Remove reservoir and 2 grommets. Remove cap and strainer from reservoir.