Front Disc Brake Pads: Removal
WARNING: This page is about a different car, the 2004 Toyota Corolla and 2003 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support vehicle. Remove wheel and tire assembly. Temporarily install wheel lug nuts to retain rotor position. Remove brake caliper from torque plate and wire aside, leaving brakeline connected. See Figure.
- Remove anti-rattle springs (if equipped), anti-squeal shims and pads. Remove pad support plates and pad wear indicators. Check rotor thickness and runout. Measure brake pads and replace if necessary. See appropriate table under DISC & DRUM BRAKE SPECIFICATIONS .
NOTE:
Some models have one or more sets of anti-squeal shims. If one set of shims is vented, place it between pad and outer anti-squeal shim.