Inspection Procedure
- PERFORM ACTIVE TEST BY OBD II SCAN TOOL OR HAND-HELD TESTER
- Check indicators and warning light operation.
- Connect the OBD II scan tool or hand-held tester to DLC3.
- Turn the ignition switch ON and push the OBD II scan tool or hand-held tester main switch ON.
- Select the ACTIVE TEST mode on the OBD II scan tool or hand-held tester.
- Check that light turn ON or OFF as the OBD II scan tool or hand-held tester directs
OK: The indicator or warning light operates normally.
INDICATOR OR WARNING LIGHT LISTSIndicator Light Warning Light Shift Position Indicator A/T OIL TEMP Warning ECT SNOW FUEL Warning ..... CHARGE Warning ..... OIL PRESSURE Warning ..... Driver's Seat Belt Warning ..... Open Door Warning
- NG: CHECK AND REPLACE COMBINATION METER ASSEMBLY
- OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE See PROBLEM SYMPTOMS TABLE .
- Check indicators and warning light operation.