Inspection Procedure

Fig 1: Identifying Connector Terminal C9-11

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Ground terminal C9-11 on the combination meter side.
2. Check that the warning light lights up.

   OK: Go to step   3 

   NG: Go to next step. 

Fig 2: Identifying Connector Terminal C9-6

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Ground terminal C9-6 on the combination meter side.
2. Check that the warning light lights up.

   NG: CHECK AND REPLACE PASSENGER SEAT BELT WARNING LAMP ASSY 

   OK: CHECK AND REPLACE COMBINATION METER ASSY 

Fig 3: Identifying Seat Belt Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Check continuity.
   1. Disconnect the front seat inner belt assy.
   2. Check the continuity in between terminals 1 and 2 of front seat inner belt assy RH.

OK: 

NG: CHECK AND REPLACE FRONT SEAT INNER BELT ASSY RH 

OK: GO TO next step 

Fig 4: Inspecting Separate Seat Type Front Seat Cushion Pad

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the separate type front seat cushion pad connector.
2. Check continuity separate type front seat cushion pad.
   FRONT SEAT CUSHION PAD CONTINUITY CHECK
   
   

   Sear condition	Terminal	Specified condition
   Released	1 - 2	No continuity
   Pressed	1 - 2	Continuity

   NG: CHECK AND REPLACE SEPARATE SEAT TYPE FRONT SEAT CUSHION PAD 

   OK: REPAIR OR REPLACE HARNESS AND CONNECTOR