Inspection Procedure

Fig 1: Identifying D BELT SW (C9-12) Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Ground terminal C9-12 on the combination meter side.
2. Check that the warning light lights up.

   NG: CHECK AND REPLACE COMBINATION METER ASSY 

   OK: GO TO next step 

Fig 2: Identifying Front Seat Inner Belt Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the front seat inner belt assy.
2. Check continuity front seat inner belt assy.

NG: REPLACE FRONT SEAT INNER BELT ASSY LH 

OK 

REPAIR OR REPLACE HARNESS OR CONNECTOR